Caveats
TIMING: type set to 'unknown' rather than guessed. No FSM for the current SU2-generation engines (G1.5 MPI, 1.4/1.5 T-GDI, U2 1.5 CRDi) was available on disk, and the Owner's Manual/PMS chart source (MAINTENANCE.md) does not explicitly state chain vs belt for these engines. The PMS chart lists no scheduled timing-belt replacement item, which is suggestive of a chain, but this is not a confirmed statement. The 1st-generation GS Creta (2015-2020, different 1.6L Gamma/Nu petrol and U2 1.6/1.4 CRDi diesel engines) FSM explicitly documents a timing CHAIN (chapter headings 'timing_chain_cover'/'timing_chain', no 'timing_belt' references) - but manifest.json explicitly cautions that GS engine-specific data does NOT carry over to the current SU2 1.5L engine family, so this was not used to populate the field. | Air filter interval differs by engine: G1.5 MPI 30,000km/3yr (used as main field, highest-volume India variant); G1.5/1.4 T-GDI turbo-petrol 20,000km/2yr; U2 1.5 CRDi diesel 20,000km/2yr. | Engine oil: main field uses G1.5 MPI petrol (0W-20, 3.8L). 1.4 T-GDI (2020-23 turbo) used 5W-30, ACEA A5/B5, 4.2L. U2 1.5 CRDi diesel used ACEA C5/C3/C2 (low-SAPS) 0W-30/5W-30, approx 4.8L (verify DPF/non-DPF row against OM p.3-13). Current G1.5 T-GDI (2024+) oil spec not separately itemized in the captured source table. | Coolant interval differs by fuel: petrol every 40,000km/2yr after first change at 100,000km/5yr (used as main field); diesel every 30,000km/2yr after the same first-change point. Approximate capacities from source (petrol ~6.1-6.4L, diesel ~7.0-7.2L) were left out of the structured capacity_l field because the source PDF's capacity table extraction is explicitly flagged as column-scrambled and unverified - confirm against Owner's Manual p.3-13 before use. | Brake fluid: source gives DOT-4 LV or DOT-4 as acceptable; assumed DOT-4 LV as Hyundai's genuine recommendation. Capacity approx 0.7-0.8L. | Transmission: main field reflects 6-speed MT. Other India-market transmissions: IVT (CVT, petrol) uses Hyundai genuine IVTF SP-CVT1 (~6.7L), inspect ~90,000km, replace approx 100,000-120,000km; diesel 6AT uses ATF SP-IV (~7.1L), same inspect/replace pattern; turbo-petrol 7DCT uses GL-4 70W DCT fluid (~1.6-1.7L). Severe-use conditions (common in India) may shorten these intervals per OM severe-usage chart p.9-17. | Spark plug interval differs: G1.5 MPI iridium 165,000km (used as main field); G1.5 T-GDI turbo-petrol 75,000km. Diesel engine has no spark plugs. | Valve clearance inspection (G1.5 MPI only) at approx 90,000km/108 months - informational, not a scheduled part replacement. | Severe-usage note (Owner's Manual p.9-17): dusty roads/short trips/heavy traffic (typical Indian driving) may warrant halving the oil-change judgement interval; many dealers advise oil changes at 5,000-7,500km instead of the standard 10,000km listed here. | Tyre pressure (front/rear PSI) and minimum tread depth were not found in the sourced MAINTENANCE.md/PMS material and were left null rather than guessed. | Oil filter part number not stated in any captured source. | No free full factory service manual exists on disk for the current 2nd-generation (SU2) Creta; all captured FSM/wiring PDFs are for the discontinued 1st-generation GS Creta (1.6L engines, 2015-2020/2021 Russia) and do not confirm SU2-specific torque specs or timing-drive type. | 1st-generation GS Creta (2015-2020, 1.6 MPI/CRDi) followed the same 10,000km/1yr oil-service rhythm in India per source, but is otherwise out of scope for the current model's per-field data above.
Source: Moto365 car-manuals collection. Always confirm against your owner's manual; intervals vary by engine and market.